Expansion Relay Smart MCodes

M410 Expansion Relay 1, Off
This will turn Expansion Relay 1 off
M411 Expansion Relay 1, On
This will turn Expansion Relay 1 on.

M420 Expansion Relay 2, Off
This will turn Expansion Relay 2 off
M421 Expansion Relay 2, On
This will turn Expansion Relay 2 on.

M430 Expansion Relay 3, Off
This will turn Expansion Relay 3 off
M431 Expansion Relay 3, On
This will turn Expansion Relay 3 on.

M440 Expansion Relay 4, Off
This will turn Expansion Relay 4 off
M431 Expansion Relay 4, On
This will turn Expansion Relay 4 on.

M450 Expansion Relay 5, Off
This will turn Expansion Relay 5 off
M451 Expansion Relay 5, On
This will turn Expansion Relay 5 on.

M460 Expansion Relay 6, Off
This will turn Expansion Relay 6 off
M461 Expansion Relay 6, On
This will turn Expansion Relay 6 on.

M470 Expansion Relay 7, Off
This will turn Expansion Relay 5 off
M471 Expansion Relay 7, On
This will turn Expansion Relay 7 on.

M480 Expansion Relay 8, Off
This will turn Expansion Relay 8 off
M481 Expansion Relay 8, On
This will turn Expansion Relay 8 on.

Smart WiFi Relay Smart MCodes

Confirm the the Smart WiFi Relays are enabled before attempting to use them. This is done from the Settings->Initial page as shown.

M490 Smart WiFi Relay, Off
This will turn a Smart Wifi Relay Off, it is used as follows:
    M490 P1001
    M490 P1002

The P parameter is automatically created when you set a Relay as Control Allowed in the SmartScreen Utility (NickName)

M491 Smart WiFi Relay, On
This will turn a Smart Wifi Relay On, it is used as follows:
    M491 P1001
    M491 P1002

The P parameter is automatically created when you set a Relay as Control Allowed in the SmartScreen Utility (NickName)

M492 Smart WiFi Relay, All Off, it is used as follows:
    M492

M493 Smart WiFi Relay, All Off, it is used as follows:
    M493

M494 Smart WiFi Relay, Time Delay On, it is used as follows:
    M494 P1000 Q10

The P parameter is automatically created when you set a Relay as Control Allowed in the SmartScreen Utility (NickName)
The Q parameter is the time delay in seconds

M495 Smart WiFi Relay, Time Delay Off, it is used as follows:
    M495 P1000 Q30

The P parameter is automatically created when you set a Relay as Control Allowed in the SmartScreen Utility (NickName)
The Q parameter is the time delay in seconds